SINFONIA (SHINKO) Controller C10-4DM

SINFONIA (SHINKO) Controller
C10 Series : Dual Motion Parts Feeder Controller
Model : C10-4DM

- Input Power Source :-
:- AC200-230V+,-0%, 50/60 Hz

- Output Control System :-
:- PWM System

- Output Voltage :-
:- Voltage : 0~190V
:- Frequency : 0~45Hz, 65~120Hz, 90~180Hz

- Output Maximum Current :-
:- Horizontal : 4A, Vertical : 2A

- Operating Mode :-
:- Standard drive : Automatic tuning to horizontal resonance point. By amplitude phase control without frequency setting

- Additional Features :-
:- Constant phase difference control : Horizontal/vertical amplitude phase difference kept constant
:- Speed selection : Choice of 4 pre-set speeds by external signal
:- Start/Stop control : Stops and starts by external signal
:- Output signal : Outputs signal tuned to unit operation
:- Soft start : Start-up time 0.2~4.0 seconds
:- On/Off delay timer : Delay time 0.2~60 seconds
:- Sensor power source : 3P power plug gives DC12V, max. 80Ma

- Synchronized power source
:- Function : Power source synchronized to parts feeder operation (RUN)
:- Control system : On/Off control through a triac
:- Output voltage : As power source input to controller

- Other :-
:- Max. current : 2A
:- Noise resistant voltage : Above 1000V
:- Ambient temperature range : 0 to 40
:- Ambient humidity range : 10+.-90% (No condensation)
:- Applicable Space : Indoor (Place where no corrosive gas, and dust.)
:- Color of case : Japan Paint Industry Association U75-70D
:- Weight : 2.0kg
- Compatible equipment
:- DM-30C, 38C, 45C, 65C, DMS-15C, 20C, 25C, 30C, 38C, 45C

Mfg. SINFONIA TECHNOLOGY CO., LTD.
Mfg. SHINKO ELECTRIC CO., LTD.
Made in Japan